产品分类
ProductsBANNER-LT3PILV激光测距仪现货
BANNER-LT3PILV激光测距仪现货
BANNER-LT3PILV激光测距仪现货
LT3 Series: Laser Retroreflective Time-of-Flight S
Range: 500 mm to 50 m; 12-24 V dc
Outputs: Discrete: PNP Analog 4-20 mA
2 m (6.5 ft) Cable
Part Number: 67279
Sensing Mode (General) Retroreflective
Sensing Mode (Detailed) Time of Flight
Housing Style Rectangular
Primary Housing Material ABS
Indicator LED(s)
Analog Output Configuration 4-20 mA
Analog Resolution/Discrete Repeatability 5 to 6 mm at slow response time
Max Sensing Distance (mm) 50000
Minimum Sensing Distance (mm) 500
Sensing Beam Visible Red Laser
Power Supply 12-24 V dc
Delay at Power-up (ms) 1000
Sensing Beam Wavelength (nm) 658
Adjustments Push Button; Remote Teach
Temperature Effect (mm/°C) 3 mm/°C
Connection Cable
QD Type/Cable Length 2 m
Number of Pins 8
Output Saturation Voltage PNP Outputs < 1.2 V at 10 mA; < 1.6 V at 100 mA
Analog Current Output Rating 1 k? max @24 V dc, max load resistance = [(Vcc-4.5 V)/0.02 A] ?
Max Discrete (Switched) Output (mA) 100
Discrete (Switched) Outputs 1 PNP
Output Protection Protected against short circuit conditions
IP Rating IP67
NEMA Rating NEMA 6
Max Operating Temperature (°C) 50
Max Op. Relative Humidity Non-Condensing (%) 90 at 50°C
Window Material Acrylic
Warm-up Time (minutes) 30
Minimum Response Time (ms) 1
Spot Size (@ Reference Distance) 6 mm
Analog Linearity (mm) +/- 60 mm from 0.5 to 50 m
Minimum Window Size (mm) 40
Remote Teach and Laser Control Input Impedence 18 k? min. (65 k? min at 5 V dc)
Discrete Output Hysteresis (mm) 6
Laser Control Yes
Laser Classification Class 1
Max Ambient Light (Lux) 5000
Max Off-state Leakage Current (µA) 5
Power/Current Consumption (exclusive of load) 108 mA max @ 24 V dc
Supply Protection Circuitry Protected against reverse polarity and transient overvoltages
Typical Laser Lifetime (Hours) 75000
Feature: Remote Teach Yes
Feature: Timing (Hold/Delay) No
Feature: Chemical Resistant No
IO Link No
Wireless No
Input/Output Analog & Discrete
传感方式(一般)反射
感应模式(详细)飞行时间
住宅风格的矩形
主要外壳材料
指示灯(s)
4-20 mA模拟输出配置
模拟分辨率/离散可重复性5至6毫米在慢速响应时间
马克斯感应距离(毫米)50000
zui小传感距离(mm)500
感应光束可见红光激光器
24 V直流电源
Delay在上电(MS)1000
感应光束波长(nm)658
调整按钮;远程教学
温度效应(mm /°C)3毫米/°C
连接电缆
QD型/电缆长度2米
针脚数8
输出饱和电压PNP输出1.2 V在10毫安;< 1.6 V在100毫安
模拟电流输出额定值1 K?马克斯@ 24伏直流电,zui大负载电阻= [(vcc-4.5 V)/ 0.02 ]?
Max Discrete(开关)输出(MA)100
离散(开关)输出1 PNP
输出保护,防止短路条件
IP防护等级IP67
NEMA等级NEMA 6
马克斯工作温度(°C)50
zui大工作相对湿度不凝结(%)90在50°C
窗口材料丙烯酸
预热时间(分钟)30
zui小响应时间(毫秒)1
光斑尺寸(@参考距离)6毫米
模拟线性度(毫米)+ / - 60毫米从0.5到50米
zui小窗口大小(mm)40
远程教学和激光控制输入阻抗18 K(65 K??min min 5 V DC)
离散输出滞后(毫米)6
激光控制是
激光分类1级
zui大环境光(力士)5000
zui大断态漏电流(µ一)5
电源/电流消耗(负载除外)108毫安zui大@ 24伏直流
电源保护电路反极性保护和暂态过电压
典型激光寿命(小时)75000
特点:远程教学是
特点:定时(保持/延迟)没有
特点:化学抗性无
IO链路没有
无线无
输入/输出模拟和离散